1, trip computer prompted to replace:

There is a general car dashboard brake warning lights, warning lights to remind you when to check the brake pads, but the warning lights explained that it had to replace the limit of the car involved in the piece, it must be checked immediately replaced. All vehicles have this warning system, but some direct induction brake lining thickness, while others are completely finished grinding of brake pads, brake fluid will cause extreme drop warning lights. Therefore, each time into the plant maintenance should be checked whether the brake pads can be used, and close to the life of the floor earlier to replace the brakes, but do not just take warning lights.

 

Warning Light

 

2, brakes comes alarm sheet Tip:

Some of the old section of the vehicle brakes is not connected to the trip computer, but on the brake pads installed an alarm of small iron pieces. When the friction material is worn running out of time, the brakes would not wear to brakes, but the small iron piece of alarm. In this case the vehicle will be issued a harsh friction between the metal "chirp" sound, that is to replace the signal of the brake pads.

 

3, the braking force feeling

In the end there is no soft brake, in fact, as the owner of your most clear if the braking effect is significantly worse than before, significantly reduced braking effect, even if there is no alarm condition occurs just said, then I suggest you go check to see need to replace, foolproof.

 

4, daily inspection

Check the brake pads and brake discs is thin, can use a small flashlight to observe the inspection, when inspection found that black friction material brake pads wear faster system gone, the thickness is less than 1/3 of its original thickness should be considered to be replaced. And each driving 5000 kilometers sure to check the brakes again.

 

New brake pads to more than 200 kilometers before the run was the effect of the slow test for good after a few more step on the brakes in order to eliminate the gap and the brake shoe plate, resulting in the first leg no brakes. After a run-in period, it will feel noticeably better braking performance, after all brake pads thick it!